Advanced Setup
As a prerequisite for this installation, the ESPHome add-on must be installed in Home Assistant. The integrated ESP32 microcontroller ensures a stable Wi-Fi connection. Once installed, you will have full control over the new device, including access to multiple parameters.
-
Please follow this link if you don't have ESPHome Builder installed in Home Assistant;
-
Connect the sensor to the computer where Home Assistant is running;
-
Go to ESPHome Builder tab and click on "NEW DEVICE" button at the right bottom corner;
-
Give it a name and click "NEXT";
-
Skip the next step;
-
Select device's type by clicking "ESP32-C3", then skip the next step;
-
Find the newly created device and click "EDIT";
-
Append the following YAML snippet to the end of device's configuration;
-
Click the “Save” button, then the “Install” button at the top right corner;
-
In the dialog that appears, select the third option: "Plug into the computer running ESPHome Device Builder";
-
You will have to select the USB port with your connected device;
-
Upon successful installation, the device will start reporting the states in the logs;
-
Close the logs by clicking "Stop" at the right bottom corner (it closes the log window, and does not stop the service);
-
Under "Settings" -> "Devices" you should see the newly discovered ESPHome device. Click "ADD" button;
-
Set the area and click on "FINISH";
-
Find and click the newly created device;
-
Congratulations! You have successfully finished the installation. Now you can automate your environment!
Swivel Joint Adjustment
-
Loosen the joint screw with a Phillips screwdriver to unlock the joint;
-
Adjust the joint as needed;
-
Tighten the screw to lock the joint.
